Airbag module board pinouts

Where to connect your programmer on the board of an airbag control unit, so you can read the memory yourself — with any tool that supports the chip — and upload the dump for crash data reset.

Every drawing is our own. Signal names are the ones on your tool’s connector.

Before you start

Boards

VW40 airbag module 1EA 959 655 / 1ED 959 655 (Infineon TC233)

BrandVolkswagen
ChipInfineon AURIX TC233 (TC23xx-32F)
InterfaceJTAG
ReadData flash (DFLASH) of the TC233: 128 KB, address 0xAF000000, length 0x20000
CheckedThese test points were used to read a 1EA 959 655 CL module in our workshop.
VW40 (1EA / 1ED 959 655) board: VCC, GND, TCK, TMS, TDI, TDO, TRST, RESET test points enlarged
Test points enlarged. Board side you see after removing the cover; the connector is at the bottom edge. Tap the picture to open it full size.
VW40 (1EA / 1ED 959 655) whole board with the test point area marked
Whole board. The orange frame marks the area with the test points.

Signals

SignalWhere on the board
VCCright end of the same capacitor
GNDleft end of the small capacitor
TCKround test pad
TMSround test pad
TDIround test pad
TDOround test pad
TRSTround test pad
RESETright-hand pad of the small resistor

Part numbers with this board (78)

Before you fit the module back: clearing crash data does not repair the car. Deployed airbags, used pretensioners and damaged sensors must be replaced and the system checked fault-free before the vehicle goes back on the road.